Collection and Preservation of 24-Hour Urine Specimens Patient: The 24-hour collection container may contain chemicals (as a preservative) that are hazardous. DO NOT urinate directly into the container. Collect urine in a clean, dry vessel and carefully pour the urine into the 24-hour collection container.- Follow your physician’s advice regarding any food, drink or drugs before and during collection.
- Empty your bladder completely upon awakening and discard this urine. This is your start date and time. Write it on your paperwork and/or the collection container.
- Collect all urine for the next 24 hours. The last urine collected should be that voided upon awakening the second day, at the same time as the start time.
- Recap the collection container carefully and completely.
- Return the collection container to where you were instructed to return it as soon as possible.
NOTE: Some urine tests require that the 24-hour urine collection be refrigerated during collection. Follow your physician’s instructions for all collection procedures.Provider/Nurse: If it is necessary to measure the total amount of soluble substances excreted in a 24-hour period, a strictly timed 24-hour specimen is required, because many soluble substances exhibit diurnal variations. - Collect the specimen in one or more disposable, wide-mouthed, clean plastic container(s) with a plastic lid large enough to hold about 3 L. Amber-colored containers may be required for light-sensitive analytes.
- Determine if the collection will require a preservative, ensuring the collection container has the appropriate preservative, at the correct concentration, along with a warning label indicating the preservative in use.
- Label the collection container including the patient identification (name and hospital number), test(s) required, and preservative used.
- The start date and time plus the finish date and time should be recorded on the container and requisition at the beginning and end of the collection period.
- The 24-hour collection should begin by having the patient empty his or her bladder or catheter bag at a fixed time and discard the specimen. Record this start date and time on the collection container and on the laboratory requisition.
- If a preservative is required, the patient must be advised to collect the urine in a separate clean container and then carefully transfer the urine to the collection container that will be transported to the laboratory. Comment: Assume that all preservatives are hazardous (most are).
- Instruct the patient (or nurse) to collect all voided urine during the 24-hour collection period and add it to the collection container.
- The collection should end exactly 24 hours after it began, by having the patient empty his or her bladder, or catheter bag, and adding this specimen to the collection container.
- Record the ending date and time on the collection container and on the laboratory requisition.
- Carefully seal the cap tightly so as to avoid leakage.
Consult the following on-line resources: Department of Nursing Services and Patient Care policies: Pathology Laboratory Services Handbook: Specimen Collection Procedures: Urology Urine Collection Procedure URINE SPECIMENS TYPES AND COLLECTION PROCEDURES I. PRINCIPLE Collection and transportation of urine specimens to the clinical laboratory are important because variables such as collection method, container, transportation, and storage affect the analysis outcome and consequently diagnostic and therapeutic decisions based on the results. Clinical staff are responsible for patient instruction, collection and labeling of urine specimens and timely transportation of specimens to the Laboratory. II. SPECIMEN REQUIREMENTS A. Specimen types 1. Random specimen For chemical and microscopic examination, a voided specimen is usually more suitable. A randomly collected specimen may be collected at unspecified times and is often more convenient for the patient. A random specimen is suitable for most screening purposes. 2. First morning specimen or 8-hour specimen The patient should be instructed to collect the specimen immediately upon rising from a night’s sleep. Other 8-hour periods may be used to accommodate insomniacs, night-shift workers, and in certain pediatric situations. The bladder is emptied before lying down and the specimen is collected on arising so that the urine collected only reflects the recumbent position. Any urine voided during the night should be collected and pooled with the first morning voided specimen. 3. Fasting specimen This differs from a first morning specimen by being the second voided specimen after a period of fasting. 4. 2-Hour postprandial specimen The patient should be instructed to void shortly before consuming a routine meal and to collect a specimen 2 hours after eating. 5. 24-hour (or timed) specimen To obtain an accurately timed specimen, it is necessary to begin and end the collection period with an empty bladder. The following instructions for collecting a 24-hour specimen can be applied to any timed collection (consult test requirements to determine if a special preservative is required): Day 1 – 7 AM: Patient voids and discards specimen. Patient collects all urine for the next 24 hours. Day 2 – 7 AM: Patient voids and adds this urine to the previously collected urine. 6. Catheterized specimen This specimen is collected under sterile conditions by passing a hollow tube through the urethra into the bladder. 7. Midstream “clean catch” specimen This specimen provides a safer, less traumatic method for obtaining urine for bacterial culture. It also offers a more representative and less contaminated specimen for microscopic analysis than the random specimen. Adequate cleansing materials and a sterile container must be provided for the patient. The procedure for the collection of a “clean catch” urine is described below in section VI of this policy. 8. Suprapubic aspiration Urine may be collected by external introduction of a needle into the bladder. It is free of extraneous contamination and may be used for cytologic examination. 9. Pediatric specimens This may be a sterile specimen obtained by catheterization or by suprapubic aspiration. The random specimen may be collected by attaching a soft, clear plastic bag with adhesive to the general area of both boys and girls. B. Transportation of specimens Urine specimens should be delivered to the within 2 hours of collection or refrigerated and transported to the lab as soon as possible. III. REAGENTS AND SUPPLIES (for collection of “clean catch” specimens) A. Disposable, clean, dry, leak-proof container (sterile container with lid required for microbiological cultures) B. Screw top specimen tube C. Disposable gloves D. Betadine swabs (Hibiclens if allergic to betadine) E. Dry, clean gauze F. Patient’s bedpan or urinal, if patient is unable to go the bathroom. IV. CALIBRATION No calibration is required for this procedure. V. QUALITY CONTROL Identification of the patient must be performed by asking a conscious patient his or her full name and birthdate. Verify by checking the identification band if available. VI. PROCEDURE A. Patient preparation: For FEMALE patients: 1. Wash hands thoroughly before beginning the procedure and put on disposable gloves. 2. Use betadine swabs or Hibiclens to cleanse the perineal area. a. Separate the folds of the labia and wipe the betadine swab or Hibiclens from front to back (anterior to posterior) on one side, then discard swab or towelette. b. Using a second betadine swab or Hibiclens, wipe the other side from front to back, then discard. c. Using a third betadine swab or Hibiclens, wipe down the middle from front to back, then discard. d. Pat dry periurethral area with clean dry gauze to remove excessive betadine while keeping the labia separated. For MALE patients: 1. Wash hands thoroughly before beginning the procedure and put on disposable gloves. 2. If the patient is not circumcised, pull the foreskin back (retract the foreskin) on the penis to clean and hold it back during urination. 3. Using a circular motion, clean the head of the penis with betadine swabs or Hibiclens. Discard the swab or towelette. B. Urination should begin, passing the first portion into the bedpan, urinal, or toilet. C. After the flow of urine has started, the urine specimen container should be placed under the patient collecting the midportion (midstream “clean catch”) without contaminating the container. D. Any excess urine can pass into the bedpan, urinal, or toilet. E. Cover the urine container immediately with the lid being careful not to touch the inside of the container or the inside of the lid. F. Transfer urine to specimen tube if tubes are used for transport instead of urine containers. G. Attach label to tube or container and place specimen in the transport bag. H. Remove gloves and wash hands. I. Record date and time of collection and initials of the person collecting (or submitting) the specimen on the specimen container. Transport specimen to the Laboratory within 2 hours of collection or refrigerate and transport to the lab as soon as possible. VII. CALCULATIONS Not applicable. VIII. REPORTING RESULTS Not applicable. IX. PROCEDURAL NOTES Specimens submitted for routine urinalysis should be collected in clean, dry containers. The specimen may be random, first morning, fasting, 2-hour postprandial, 24-hour (or timed), catheterized, midstream, clean-catch, or suprapubic aspiration. The specimen should be submitted to the lab in a plastic screw-top transfer tube or specimen cup. Specimens submitted in syringes will not be accepted by the laboratory. The specimen containers must be properly labeled with appropriate patient identification including: name, medical record number, date of birth/age, the date and time of collection, and initials of the person collecting (or submitting) the sample Specimens should be submitted to the laboratory immediately. A specimen for urinalysis should be examined while fresh. Specimens left at room temperature will begin to decompose resulting in chemical and microscopic changes. A minimum of 12 ml of urine should be submitted for analysis. Smaller sample quantities will be analyzed but the statement “QNS FOR ACCURACY: < 5 ML SUBMITTED FOR ANALYSIS” will accompany results of those specimens with volumes < 5 ml., e.g., babies or newborns. SPECIMENS FOR PREGNANCY TESTING First morning specimens are the best for pregnancy testing because the urine is more concentrated. SPECIMENS FOR OSMOLALITY No special sample preparation is required. Whole blood, serum, plasma, or urine may be used. X. LIMITATIONS OF PROCEDURE A. Specimens submitted in syringes will not be accepted. B. Specimens improperly labeled must be discarded and recollected. C. Urine osmolality cannot be collected with preservatives. D. Urine samples leaking in the collection bag are unacceptable.
How soon should urine be tested after collection?
If you can't hand your urine sample in within 1 hour, you should put the container in a sealed plastic bag then store it in the fridge at around 4C. Do not keep it for longer than 24 hours. The bacteria in the urine sample can multiply if it is not kept in a fridge.
How soon after the collection of a urine sample should it be tested in the laboratory quizlet?
A urine specimen must be tested within one or two hours of collection. If testing is not possible within that time frame, the specimen must be refrigerated to preserve the components. A routine urinalysis consists of three parts: physical, chemical, and microscopic examination.
How must urine specimens be handled after collections?
If possible, the entire specimen should be refrigerated at 2°C to 8°C during collection, or kept in a cool place, since urine is an excellent culture medium for organisms, and its components decompose quickly.
|